Page 1 of 1

Switch housing ID please

PostPosted: Fri Aug 18, 2017 9:04 am
by SlackerThePinstriper
I'm building up a Jet headset from what I have lying about and found these.
Both are a tight fit but need a degrease and fettle

Any help appreciated

Image

Re: Switch housing ID please

PostPosted: Fri Aug 18, 2017 10:51 am
by Triffid
Hi there!
The top one is an Li type and would have been found on earlier Jets; the bottom one is an SX/GP type and was not used on Jets to my knowledge. :)

Re: Switch housing ID please

PostPosted: Fri Aug 18, 2017 1:22 pm
by SlackerThePinstriper
Triffid wrote:Hi there!
The top one is an Li type and would have been found on earlier Jets; the bottom one is an SX/GP type and was not used on Jets to my knowledge. :)



Excellent cheers mate

Re: Switch housing ID please

PostPosted: Fri Aug 18, 2017 11:19 pm
by buzz
Triffid wrote:Hi there!
The top one is an Li type and would have been found on earlier Jets; the bottom one is an SX/GP type and was not used on Jets to my knowledge. :)

both types were used on jets the top one was used on most spanish scooters from 1965 to early 70,s

early jet200's from 1966 some had the top LI type and this was changed to the bottom sx/gp type at some point for the 1967 to 69 jet 200
models then it was changed again to top type for the 1971 onward jets before they changed to the large square type in the mid 70,s