LCGB Forums

Anybody any idea on Jetting for a PHBL25 on a standard 150

Currently
60 Choke
50 Pilot
D22 Needle 2nd Clip
85 Main

I’d drop the choke to 45 and the pilot to 50.
No prove of this other than somewhere near a Muggy 186.
See how you go.
Cheers Shane

shane BBoys wrote:I’d drop the choke to 45 and the pilot to 50.
No prove of this other than somewhere near a Muggy 186.
See how you go.
Cheers Shane

Shane, are you sure you don't mean the other way round ie: choke to 50 and pilot to 45?

Rich'

what atomiser are you using ?

AQ266 Atomiser

foremanbob wrote:AQ266 Atomiser

Bit rich for a standard 150 I’d imagine
My settings on an Rt200 reedvalve below
25 delly
112 main
70 choke
45 slide
50 idle set 2 turns out
D22needle
AQ 266 Atomiser
300 float jet

Thanks chaps... first experience in trying to set one of these carbs up...

Mate just bought scooter... The seller had bodged a big block manifold onto the Li150 barrell, and used a bit of car radiator hose as the manifold rubber...

I'm having to check everything now...

Hi, can I ask did you get this tuned in - just starting to do exacty the same thing and a known set-up would be helpful to get started. Only difference I have is that I have a 42mm Clubman , but doubt it will make that much difference . . . Cheers

Will let you know once I've sorted out the starting issues.....

Hi Bob
Did you get this sorted and what was the final set up
As I've got something similar and was looking for a good starting point
Cheers
C