AF Bearing fitment

[Bilko]

For fear of looking a nob (which some will say I already am).

When I fit the bearing, the AF plate that goes on still leaves a gap? Is this right?

[Simon_T]

if you tighten that down the studs will probably bend, I may be corrected though,
I have fitted the new mb recessed plate

[Bilko]

if you tighten that down the studs will probably bend, I may be corrected though,
I have fitted the new mb recessed plate

It doesn't look good. I've tried this on two different casings. 1 Italian, 1 Indian. The MB recess plates aren't any deeper than the one it's supposed to have.

[missing lynx]

That doesn't look right I would contact AF they are good with their customer service will help you resolve the problem

[hullygully]

that is correct if you've used their recessed plate.