LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
end plate dowel
3 posts
• Page 1 of 1
end plate dowel
by a-teamlambretta » Thu Jan 14, 2016 5:10 pm
does anyone know the diameter of an endplate dowel and are they different diameter to the engine case dowel. i need to to as i have just welded a case up and need to re drill and all i have to hand is an engine case dowel. thanks simon
-
a-teamlambretta - Posts: 505
- Joined: Fri May 30, 2014 9:42 pm
- Location: gilberdyke, east yorks
Re: end plate dowel
by gp200ts1 » Thu Jan 14, 2016 5:58 pm
Just measured both and they are 7mm diameter. Part number is the same for both according to my parts book
- gp200ts1
- Posts: 277
- Joined: Fri May 30, 2014 2:43 pm
Re: end plate dowel
by a-teamlambretta » Thu Jan 14, 2016 6:16 pm
gp200ts1 wrote:Just measured both and they are 7mm diameter. Part number is the same for both according to my parts book
cheers for the info.simon
-
a-teamlambretta - Posts: 505
- Joined: Fri May 30, 2014 9:42 pm
- Location: gilberdyke, east yorks
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 5 guests