LCGB Forums

As title ,are there any alternatives to using a Nissin Caliper on a ScootRS set up ?

Cheers

You'd need to find one off a bike that was for the same diameter disc and that mounted with the same bracket / bolt spacing on the carrier.

I think that would be a bit of a challenge TBH.

I'm sure someone might have said on the SE site what the bike it is off was.

I would have thought that if you are prepared to build a new caliper bracket, then you can have a choice of calipers. I've a four pot caliper from an R1, but the brake is not the RS type.

Are you looking for something less vicious Peach? The SIP calliper on my jet works very well but as Martin said, would need a new calliper bracket.......job for CS?

Is that on the zip wheel? Or a custom carrier?

Honda CB125

coaster wrote:Are you looking for something less vicious Peach? The SIP calliper on my jet works very well but as Martin said, would need a new calliper bracket.......job for CS?

It's for Cheggers ,he's just looking for that looks better TBH , as part of his GP spruce up .

Knowledge wrote:I would have thought that if you are prepared to build a new caliper bracket, then you can have a choice of calipers. I've a four pot caliper from an R1, but the brake is not the RS type.

Good point Martin but I think he wants to use what he has - but thanks

rossclark wrote:Is that on the zip wheel? Or a custom carrier?

No just a normal ScootRS set up

foremanbob wrote:Honda CB125

Thanks