Page 1 of 1

TS1 crank choice

PostPosted: Fri Apr 15, 2016 9:58 am
by mark1
I'm currently building a TS1 engine and am undecided in what crank to fit, I know it's going to be a 60mm stroke but that's about it.

Any suggestions on make and conrod length and make?

I'm tempted by the AF crank but not quite made up my mind yet.

Re: TS1 crank choice

PostPosted: Fri Apr 15, 2016 2:25 pm
by hullygully
jap or std crown height piston? which would determine con-rod length
std webs or full circle webs?
sx or gp flywheel? (gp prefared of course)

Re: TS1 crank choice

PostPosted: Fri Apr 15, 2016 4:25 pm
by mark1
Not sure what piston I'm using yet. Was thinking about using a wossener which requires a 116 rod but not entirely sure.

I was just wondering which make of crank to use. I've got to buy a piston for the kit so am quite flexible what crank I can use.