Page 1 of 1
Cylinder head?
Posted:
Sun May 29, 2016 11:51 pmby Lammer205
Is a cylinder head that came with a kit which had a 30mm crown height piston ok to use with a piston with a 39mm crown height? Lammer205
Re: Cylinder head?
Posted:
Mon May 30, 2016 12:26 amby rossclark
Should be, but check the profile of the piston crown to the head and confirm the squish setting.
You should also check the final compression ratio.
Re: Cylinder head?
Posted:
Mon May 30, 2016 7:53 amby Lammer205
Thanks for that ,Yeah it's 9.1 comp ratio will check squish and try it hopefully be ok.Lammer205
Re: Cylinder head?
Posted:
Mon May 30, 2016 9:25 amby gaz_powell
If is a purpose made lam piston ie racetour/bgm, af wosner etc then yes as they use the same crown profile as traditional lam, but it jap you will have to rework the head profile. I had to on my yam it 175 in a ts1 and in a malossi 172 with a suzuki ts185 in a vespa.
And as said always check the squish.
Re: Cylinder head?
Posted:
Mon May 30, 2016 9:31 amby Lammer205
Yeah going from MRB to Wossner just different crown heights so you think ok?Lammer205