Old Honda 205 kit.

[kevspeed]

Just dug out an old Honda 205 kit,just the barrel and head.
Obviously the head was profiled for the MTX 200 piston,but im sure i can use the barrel for something else.
Can anybody remember how much was taken from the base and the top of the barrels to accomodate the MTX piston?
I have a new TS1 225 piston,and an 'Atomic' reed manifold.
My idea being to get the three together as a nice 225 kit,but i cant remember by how much the barrel was machined by!

[rossclark]

I measured a standardish barrel from under the bench and it is about 102.5 mm between the gasket faces if that helps.

[dscscotty]

Just dug out an old Honda 205 kit,just the barrel and head.
Obviously the head was profiled for the MTX 200 piston,but im sure i can use the barrel for something else.
Can anybody remember how much was taken from the base and the top of the barrels to accomodate the MTX piston?
I have a new TS1 225 piston,and an 'Atomic' reed manifold.
My idea being to get the three together as a nice 225 kit,but i cant remember by how much the barrel was machined by!

1mm with 107mm rod @ 58mmstroke