LCGB Forums

Just dug out an old Honda 205 kit,just the barrel and head.
Obviously the head was profiled for the MTX 200 piston,but im sure i can use the barrel for something else.
Can anybody remember how much was taken from the base and the top of the barrels to accomodate the MTX piston?
I have a new TS1 225 piston,and an 'Atomic' reed manifold.
My idea being to get the three together as a nice 225 kit,but i cant remember by how much the barrel was machined by!

I measured a standardish barrel from under the bench and it is about 102.5 mm between the gasket faces if that helps.

Just dug out an old Honda 205 kit,just the barrel and head.
Obviously the head was profiled for the MTX 200 piston,but im sure i can use the barrel for something else.
Can anybody remember how much was taken from the base and the top of the barrels to accomodate the MTX piston?
I have a new TS1 225 piston,and an 'Atomic' reed manifold.
My idea being to get the three together as a nice 225 kit,but i cant remember by how much the barrel was machined by!

1mm with 107mm rod @ 58mmstroke