Hydraulic brake master cylinder

[burnside]

Can anyone advise what the bolt size (width, length and pitch) is for attaching mirror/other accessories to the master cylinder?

[Knowledge]

I think there maybe two common sizes.

Something like M8 and an M10 fine pitch.

I am sure a grown up will come along in a minute to clarify

[Rich Oswald]

I think there maybe two common sizes.

Something like M8 and an M10 fine pitch.

I am sure a grown up will come along in a minute to clarify

Correct Martin and Lambretta Restore sell an adaptor to take either. I'm not a grown up though

Rich'

[HxPaul]

If your using a nissin(or similar)master cylinder,the place where the rear view mirror is attached is an m10 thread.I think a standard Yamaha,Suzuki etc.rear view mirror fits.

[burnside]

Thanks guys. Already got a mirror (I could measure that it's at home and I'm in the middle of ordering a load of fixings) but this is to attach a bracket that will hold my SatNav. M10 fine pitch sounds right, just the length now that I'm not sure on

[Knowledge]

Length?

Buy a long one and a hacksaw......

[burnside]

Length?

Buy a long one and a hacksaw......

Cheers Martin

[coaster]

Thanks guys. Already got a mirror (I could measure that it's at home and I'm in the middle of ordering a load of fixings) but this is to attach a bracket that will hold my SatNav. M10 fine pitch sounds right, just the length now that I'm not sure on

My mirror bolt thread length is about 15-20 mm at a guess and that's on a ScootRs type Nissin master cylinder.

[burnside]

Thanks guys. Already got a mirror (I could measure that it's at home and I'm in the middle of ordering a load of fixings) but this is to attach a bracket that will hold my SatNav. M10 fine pitch sounds right, just the length now that I'm not sure on

My mirror bolt thread length is about 15-20 mm at a guess and that's on a ScootRs type Nissin master cylinder.

Cheers Colin, same master cylinder as your then I think