LCGB Forums

by **Bilko** » Thu Feb 06, 2020 9:58 pm

It's showed no signs of letting up after several thousand miles.

by **Andy B.L.C.** » Fri Feb 07, 2020 12:19 am

Would that be missing a 'no' somewhere B, or not, distinction important? Sounds like what I'm needing to sort out my Poland rally oil leak! It wasn't a leaking BGM side casing casket but a post end plate fixing welding job pin prick leak...

by **Psychedelicropcircle** » Sun Feb 09, 2020 1:45 pm

Used some JB kwik weld drilled a wee hole to let it grip a bit better. Leak test it after graft tomorrow! :cry:

by **coaster** » Mon Feb 10, 2020 6:07 pm

+1 for JB weld but do make sure its fully cured before starting the engine. I got a little over enthusiastic cutting a finger port in a SR225 barrel once, slapped some JB Weld on it, popped the barrel on then thought it would be a good idea to take it for a quick spin.....didn't even make to the end of the drive :oops:

2nd attempt worked as I left it to cure for 24 hours 8-)

by **Psychedelicropcircle** » Tue Feb 11, 2020 5:29 pm

Sorted

Gearbox next

by **Toddy** » Tue Feb 11, 2020 10:55 pm

Psychedelicropcircle wrote:Sorted

Gearbox next

Happy days , 5 speed ?

by **Psychedelicropcircle** » Wed Feb 12, 2020 11:29 am

Toddy wrote:
Psychedelicropcircle wrote:Sorted

Gearbox next

Happy days , 5 speed ?

Aye the budget AF one!

by **Toddy** » Wed Feb 12, 2020 11:34 am

Psychedelicropcircle wrote:
Toddy wrote:
Psychedelicropcircle wrote:Sorted

Gearbox next

Happy days , 5 speed ?

Aye the budget AF one!

Just fitted af one in my 240 not ridden yet though

LCGB Forums

pinprick airleak in barrel wall

Re: pinprick airleak in barrel wall

Re: pinprick airleak in barrel wall

Re: pinprick airleak in barrel wall

Re: pinprick airleak in barrel wall

Re: pinprick airleak in barrel wall

Re: pinprick airleak in barrel wall

Re: pinprick airleak in barrel wall

Re: pinprick airleak in barrel wall

Who is online