I have a TV 175 cylinder with a fracture in the spigot.
Can it be welded and then machined?
Thanks.
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
Damaged Barrel
5 posts
• Page 1 of 1
Damaged Barrel
by Littlewheels » Wed Jul 19, 2023 11:43 pm
- Littlewheels
- Posts: 154
- Joined: Mon Apr 27, 2020 8:26 pm
Re: Damaged Barrel
by Fast n Furious » Fri Jul 21, 2023 1:30 am
If the crack veers off toward the periphery of the spigot then it's probably time to change it.
If it's more or less vertical, then it probably could remain servicable by drilling a hole through the spigot at the end of the crack to relieve the stress.
If it's more or less vertical, then it probably could remain servicable by drilling a hole through the spigot at the end of the crack to relieve the stress.
-
Fast n Furious - Posts: 1654
- Joined: Sat Nov 19, 2016 3:56 am
- Location: York
Re: Damaged Barrel
by hullygully » Fri Jul 21, 2023 8:41 am
30mm, so that'd leave you about 25mm if you got it machined off upto the crack?
I have a TS1 barrel that's machined down cos of a cracked spigot.
the quatrini's don't have a spigot, so I'd have thought if you have 25mm of spigot then even for locating purposes its doin its job
I have a TS1 barrel that's machined down cos of a cracked spigot.
the quatrini's don't have a spigot, so I'd have thought if you have 25mm of spigot then even for locating purposes its doin its job
- hullygully
- Posts: 2221
- Joined: Thu Jun 05, 2014 1:28 pm
- Location: Hull
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 14 guests