hi all
does anybody know the exact thread size for the lambretta end plate studs,
I know they are M7 studs but does anybody know what the exact thread pitch is i need to clean a couple of stud holes out with a tap but i am not sure on the exact thread pitch.
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
end plate stud thread pitch size
2 posts
• Page 1 of 1
end plate stud thread pitch size
by maddogmadox » Sun Mar 22, 2015 10:54 pm
- maddogmadox
- Posts: 73
- Joined: Sat May 31, 2014 2:52 pm
- Location: Manchester
Re: end plate stud thread pitch size
by Warkton Tornado No.1 » Mon Mar 23, 2015 12:22 am
Hi
The end plate studs are 1 mm pitch (M7 x 1.0) & the original studs were strong (or tough), as they had rolled threads rather than cut threads.
They are exactly the same pitch as 'normal' M6 threads but 1 mm bigger in diameter & correspondingly stronger with their bigger cross section.
I hope that helps.
Mark
The end plate studs are 1 mm pitch (M7 x 1.0) & the original studs were strong (or tough), as they had rolled threads rather than cut threads.
They are exactly the same pitch as 'normal' M6 threads but 1 mm bigger in diameter & correspondingly stronger with their bigger cross section.
I hope that helps.
Mark
- Warkton Tornado No.1
- Posts: 2234
- Joined: Sun Jan 11, 2015 1:27 pm
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: Google [Bot] and 15 guests