Could any members give me the size of the above carb where one would fit an airfilter ?
Where I am right now I can buy quite cheaply.
Either the O/D or just across the inlet from side to side so as I dont buy one too small or too big.
Thanks chaps
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
Jetex 22mm size air filter O/D
3 posts
• Page 1 of 1
Jetex 22mm size air filter O/D
by duncan1958 » Sun May 10, 2015 2:17 am
Currently away from my selection of scooters
Could any members give me the size of the above carb where one would fit an airfilter ?
Where I am right now I can buy quite cheaply.
Either the O/D or just across the inlet from side to side so as I dont buy one too small or too big.
Thanks chaps
Could any members give me the size of the above carb where one would fit an airfilter ?
Where I am right now I can buy quite cheaply.
Either the O/D or just across the inlet from side to side so as I dont buy one too small or too big.
Thanks chaps
- duncan1958
- Posts: 136
- Joined: Sun Jun 01, 2014 5:14 pm
Re: Jetex 22mm size air filter O/D
by rossclark » Sun May 10, 2015 4:22 pm
Standard SH2/22 under my bench is 45mm OD same as the alloy bellmouth on my PHBH.
-
rossclark - Posts: 2855
- Joined: Fri May 30, 2014 11:23 pm
- Location: Lanarkshire
Re: Jetex 22mm size air filter O/D
by duncan1958 » Mon May 11, 2015 6:10 am
rossclark wrote:Standard SH2/22 under my bench is 45mm OD same as the alloy bellmouth on my PHBH.
Many thanks for the size
- duncan1958
- Posts: 136
- Joined: Sun Jun 01, 2014 5:14 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests