by Captain Pugwash » Fri Jun 26, 2015 12:08 pm
Stuck plates if it's stood for a long time.
What I did on a couple of mates scooters was put the front wheel against a wall sit on the scooter foot on the back brake engine running, pull the clutch in and try to select second gear a few times, it will stall at first as it jumps into gear but normally after a few second gear selections it will free off.
Just make sure the clutch cable is adjusted tight, over tighten it a little at first, then Once the clutch frees off and you can select second and back to first then into neutral readjust the cable so there is just enough slack to allow the clutch to work properly.
Expected couple of jump starts as the plates slowly bed back in.
If this fails then it's time to dig a little deeper.
Good luck, Mark.