Hi
l am a new member and need some advice I have a s3 and would like to fit front dampers I am considering using fork links with damper connection are these difficult to fit.
Cheers
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
fork links
4 posts
• Page 1 of 1
Re: fork links
by HxPaul » Mon Oct 26, 2015 9:54 pm
If its a series 3 Li,TV,SX,you will need a fork spring compressor,if its a GP or later SX with damper rods and ball bearings its possible to remove without a fork spring compressor.
-
HxPaul - Posts: 1583
- Joined: Fri May 30, 2014 9:18 am
- Location: Halifax
Re: fork links
by Digger » Tue Oct 27, 2015 10:28 am
The first one you do may take you up to two hours, much cursing and bruised fingers.
The second one about 10 minutes.
Make sure you use a decent compressor tool as there are some crap ones on the market.
The second one about 10 minutes.
Make sure you use a decent compressor tool as there are some crap ones on the market.
-
Digger - Posts: 992
- Joined: Sat May 31, 2014 4:41 am
- Location: Stroud, Gloucestershire
Re: fork links
by paul213 » Wed Oct 28, 2015 10:55 am
be careful which links you use there were some nasty sand cast ones about . tried fitting a set for someone and one snapped where the spindle goes during fitting .
- paul213
- Posts: 25
- Joined: Tue Jun 03, 2014 11:20 am
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 11 guests