tight manifold

[Scooterslag]

just putting together a engine and using a stock 20mm delly and manifold which I bought from separate sources, problem being is the manifold is way too large to insert (oh er... ) into the carb body, any decent tricks or tips to get the buggers to fit without knackering anything? cheers Paul

[Adam_Winstone]

Sure the manifold isn't intended for a 22mm carb?

[drivera]

Either find someone with a lathe who could turn down the spigot to the correct size or set too with a file ( might take a while though )

[Scooterslag]

Sure the manifold isn't intended for a 22mm carb?

Nope it the right type Adam 19.41.1004, the 20mm is off a serveta while the manifold is italian, don't know if this makes any difference, its just bloody tight Paul

[Scooterslag]

Either find someone with a lathe who could turn down the spigot to the correct size or set too with a file ( might take a while though )

yeah I was going to set to it with a file and emery cloth, I just wanted to see if there was a easier way. Paul

[Covboy]

Hi
The nylon insert reduction sleeve that goes into the carb body - I think that there are different sizes ( ie different inside diameters ) for different manifolds .

http://www.scooterrestorations.com/lamb ... on-sleeve/