LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
series3 floor runners
5 posts
• Page 1 of 1
series3 floor runners
by waynekemp » Wed Jun 15, 2016 8:19 pm
does anyone know good way to fit the rubber into the channel i have tried soaking in hot water and putting grease in Channel to no avail wayne
- waynekemp
- Posts: 12
- Joined: Thu Oct 08, 2015 8:29 pm
Re: series3 floor runners
by Rich Oswald » Wed Jun 15, 2016 8:33 pm
Boiling hot water is the clue and it also depends on the quality of the rubbers. Some cheaper ones are pretty hard, less flexible and harder to fit.
-
Rich Oswald - Posts: 9523
- Joined: Fri May 30, 2014 3:30 pm
- Location: Wiseman From The East (East Of The Pennines That Is)
Re: series3 floor runners
by waynekemp » Wed Jun 15, 2016 8:38 pm
Hi do you slide them up or press them in when hot
- waynekemp
- Posts: 12
- Joined: Thu Oct 08, 2015 8:29 pm
Re: series3 floor runners
by HxPaul » Wed Jun 15, 2016 8:53 pm
Put one side in and push the other side in with a flat headed screwdriver
-
HxPaul - Posts: 1583
- Joined: Fri May 30, 2014 9:18 am
- Location: Halifax
Re: series3 floor runners
by waynekemp » Wed Jun 15, 2016 9:14 pm
Thanks mate it works i struggled with other side pulling them up with pliers grease, sweat and swear words
- waynekemp
- Posts: 12
- Joined: Thu Oct 08, 2015 8:29 pm
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: Scooterslag and 30 guests