Viagra for floppy brake pedals

[Sticky]

https://www.scooterlab.uk/lambretta-brake-pedal-pin-repair-workshop/

Here's a full how-to of a tip that we mentioned in the Spanners Manual. I hope it is of assistance.

[EddieStone]

I did this to mine. Bit nerve wracking hacking off a bit of a re-built scooter, which is only surpassed by the thought of the tap snapping off, but it worked perfectly.

[Phil D]

The original brake pin is only tacked in and easily removed from the saddle .
New pins are available from S/R .
I had the circlip groove machined in and also the grease nipple thread and side hole then just re- tacked it in place having measured how far the old one stuck out .

I did't have Sticky's then so was flying by the seat of my pants.
I'm not sure if I'd have gone to all the trouble if I had.
Great idea explaining the process in more depth.
I bet theirs loads more material in the book.
Thanks.

[Wack]

If you save all your old brass gear shaft casing bushes these fit far better than the nylon pedal inserts

[Sticky]

Good point Wack