Low profile "race" seat conundrum with rear spare wheel rack

[Donnie]

And this is a TSR hinged X-Race, which I still have if you want to borrow and try, but I think the hump is still too far forward.

It does look a bit better but you're right its still too far foward for what I want. I appreciate the offer thought, very kind mate.

[Donnie]

Square back would fit. Not sure if it would look good on series 2 curves though.

Yeh, think it would look wrong

[johnnyjarvis]

Scootopia cutback wouldnt fit, peeled back the material and cut it some more ( took about an inch off ) , job done.
Allthough i started with a cutback style seat this would be just as easy to do with a full length ancilloti.

[kevspeed]

Scootopia cutback wouldnt fit, peeled back the material and cut it some more ( took about an inch off ) , job done.
Allthough i started with a cutback style seat this would be just as easy to do with a full length ancilloti.

Must be a big motor in that baby to haul around all that front and rear scaffolding!
The best looking seat arrangement so far though.

[bolzenanker]

Scootopia cutback wouldnt fit, peeled back the material and cut it some more ( took about an inch off ) , job done.
Allthough i started with a cutback style seat this would be just as easy to do with a full length ancilloti.

Nice seat, very nice scooter.

[gaz_powell]

I'm making a seat base at minute it's a full seat with a bolted rear part snetterton style that stops just before the tank aperture. Then the front part takes the rest of frame to front and hinges.
It's all built, just needs the front covering to match the back (which I used on my sx for years)

Something like that might work???

[Donnie]

I'm making a seat base at minute it's a full seat with a bolted rear part snetterton style that stops just before the tank aperture. Then the front part takes the rest of frame to front and hinges.
It's all built, just needs the front covering to match the back (which I used on my sx for years)

Something like that might work???

Nope no good to me, whole thing needs to flip for me.

[Donnie]

Scootopia cutback wouldnt fit, peeled back the material and cut it some more ( took about an inch off ) , job done.
Allthough i started with a cutback style seat this would be just as easy to do with a full length ancilloti.

The best looking seat arrangement so far though.

Have to agree there! Looks very like what I want!

Of course these are also out of stock

[Donnie]

yay got one but have to cut it too. bugger.

Anyone got experience of the best type of glue to reglue the vinyl with?

@johnnyjarvis ?

[rossclark]

Evostik

[Donnie]

which one ? http://www.bostik.co.uk/diy/brand/EVO-STIK

[rossclark]

The regular one that goes in the poly bag.

[Donnie]

Ended up with the Ancillotti which needed a trim as mentioned. Feels pretty hard at the moment so will need to break it in, done my first 50 miles running in my repaired GT186 kit today on it.

Running In GT186 by Donnie Canning, on Flickr