Slightly loose dowel on endplate

[Scooterslag]

Just rebuilding a gearbox ( Italian cases and end plate) and one of the dowels isn't loose or rocking about but you can pull out with a bit of loose pressure, everything lines up out and the studs etc are all in great condition. Anything to be concerned about or good to go? thanks Paul

[hullygully]

loctite it in place if you're worried just make sure the endplate has 2 punch marks on the outside of its hole

[Scooterslag]

loctite it in place if you're worried just make sure the endplate has 2 punch marks on the outside of its hole

Cheers figured a blob of loctite might be the answer but always prudent to check with endplate stuff, thanks Paul