LCGB Forums

The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com

Skip to content

Squish

Technical help for Series one, two and three Lambrettas. Models include the Li, Li Special, TV, SX, GP, Serveta and API/SIL models
Post a reply

Squish

Postby dave411 » Thu Oct 16, 2014 10:05 am

I am fitting a 150 barrell,head and piston to mt Li,will I need to check the squish clearence?
User avatar
dave411
 
Posts: 247
Joined: Sat Jun 07, 2014 1:31 pm
Location: Sunny Cardiff
Top

Re: Squish

Postby stonerosesmod » Thu Oct 16, 2014 12:54 pm

I would check squish on every new top end i fitted.Your looking between 1.0mm - 1.5mm ideally.
stonerosesmod
 
Posts: 101
Joined: Tue Jun 03, 2014 9:11 pm
Top

Re: Squish

Postby dave411 » Thu Oct 16, 2014 2:13 pm

Thanks,will do.
User avatar
dave411
 
Posts: 247
Joined: Sat Jun 07, 2014 1:31 pm
Location: Sunny Cardiff
Top

Re: Squish

Postby Captain Pugwash » Thu Oct 16, 2014 2:19 pm

Don't be too surprised if you are not able to get it below 1.5mm squish clearance because even without a head gasket fitted they rarely squish down to that clearance on standard parts.

Mark.
User avatar
Captain Pugwash
 
Posts: 422
Joined: Fri May 30, 2014 7:48 pm
Location: Liverpool
Top

Re: Squish

Postby dave411 » Thu Oct 16, 2014 9:43 pm

Ok,thanks for the info.
User avatar
dave411
 
Posts: 247
Joined: Sat Jun 07, 2014 1:31 pm
Location: Sunny Cardiff
Top
Post a reply

Return to Series 1, 2 & 3

Who is online

Users browsing this forum: No registered users and 15 guests

Powered by phpBB® Forum Software © phpBB Group