LCGB Forums

The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com

Skip to content

rear hub bearing fitting

Technical help for Series one, two and three Lambrettas. Models include the Li, Li Special, TV, SX, GP, Serveta and API/SIL models
Post a reply

rear hub bearing fitting

Postby Chewyboy » Sun Nov 23, 2014 9:55 pm

hi everyone
just begun rebuilding series 3 125 engine. i have drifted in the rear hub bearing (out of the freezer) after warming the casing and waiting for the change of tone when it was fully home. is it supposed to sit flush with the casing on the outside? mine is slightly proud (about 1mm) and i am concerned about tightening up the plate.
thanks in anticipation
User avatar
Chewyboy
 
Posts: 37
Joined: Thu Jul 03, 2014 10:23 pm
Location: Chesterfield
Top

Re: rear hub bearing fitting

Postby Captain Pugwash » Sun Nov 23, 2014 10:25 pm

Chewyboy wrote:hi everyone
just begun rebuilding series 3 125 engine. i have drifted in the rear hub bearing (out of the freezer) after warming the casing and waiting for the change of tone when it was fully home. is it supposed to sit flush with the casing on the outside? mine is slightly proud (about 1mm) and i am concerned about tightening up the plate.
thanks in anticipation


Sits proud
User avatar
Captain Pugwash
 
Posts: 422
Joined: Fri May 30, 2014 7:48 pm
Location: Liverpool
Top

Re: rear hub bearing fitting

Postby Chewyboy » Sun Nov 23, 2014 10:26 pm

aye aye captain
cheers
User avatar
Chewyboy
 
Posts: 37
Joined: Thu Jul 03, 2014 10:23 pm
Location: Chesterfield
Top
Post a reply

Return to Series 1, 2 & 3

Who is online

Users browsing this forum: No registered users and 114 guests

Powered by phpBB® Forum Software © phpBB Group