Just changed the speedo ring drive on the S1, what a sod of a job. Had to grind it down on both sides to get it off then to get the new one on (metal) I had to heat it up and use a wooden drift to knock it on. I always wondered what held them on, now I know!
Anyway, the worm, the one I have taken out is shorter than the new one (obviously meant for S3) so will the longer one work ok or do I need to get a short one?
Cheers,
Rich'
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
Speedo drive
5 posts
• Page 1 of 1
Speedo drive
by Rich Oswald » Sat Dec 13, 2014 11:26 am
-
Rich Oswald - Posts: 8816
- Joined: Fri May 30, 2014 3:30 pm
- Location: Wiseman From The East (East Of The Pennines That Is)
-
Rich Oswald - Posts: 8816
- Joined: Fri May 30, 2014 3:30 pm
- Location: Wiseman From The East (East Of The Pennines That Is)
Re: Speedo drive
by Dimitrios_231 » Sun Dec 14, 2014 8:16 pm
Did you buy as a pair?
If yes,use the supplied one.
You need to be very careful when assembling,
it might feel that it rubs,
go gently,use a lot of grease,
after a few miles,remove it, check and repack with grease.
If yes,use the supplied one.
You need to be very careful when assembling,
it might feel that it rubs,
go gently,use a lot of grease,
after a few miles,remove it, check and repack with grease.
-
Dimitrios_231 - Posts: 981
- Joined: Fri May 30, 2014 1:15 pm
Re: Speedo drive
by Scooter Paul » Sun Dec 14, 2014 8:21 pm
I always thought the shorter ones were for disc brake models?
Paul
Paul
- Scooter Paul
- Posts: 374
- Joined: Fri May 30, 2014 9:41 am
Re: Speedo drive
by Rich Oswald » Sun Dec 14, 2014 10:01 pm
Cheers guys, S1's are shorter according to Sticky's manual.
-
Rich Oswald - Posts: 8816
- Joined: Fri May 30, 2014 3:30 pm
- Location: Wiseman From The East (East Of The Pennines That Is)
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 123 guests