Series 3 Li150 special badge kit

[Halflife]

Hi all,

I am having a number of panels repainted on my series 3 special and I purchased a new badge set to finish it off. Had a call of the painter stating that there was nothing to secure the badges on the led shield in place. Holes are all pre drilled ready and the badges have pegs on the back to go into the holes but nothing in the kit to secure and stop them falling off.

Could anyone tell me what the proper way to secure the badges is please?

Thanks in advance for the help

Halflife

[rossclark]

You have to peen the pin over to secure the badge.

You can get a tool for this or use a punch and hammer (carefully) with a soft wooden block on the other side