A bit more work on the legshield. There’s no no point in going too far until the frame has been on the jig and any remedial work done.
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
Knowledge wrote:The only engine modification I did to my standard TV175 was to machine the head to give a sensible squish. I think mine was in excess of 2.5mm so I took it back down to about 1.3mm. I probably need to do a compression calculation before I run the machine as it may now be prone to overheating due to a higher compression.
Leave that one with me.
Users browsing this forum: No registered users and 4 guests