Hi All recently build a Series 3 Li 150 Special. Upgraded to a 195 and installed a YSN PHBH 28 Carb. Jetting is as follows:
Pilot - 55
Needle - X13
Atomizer - AV266
Slide - 120
Choke - 200
Problem: The engine starts fine with choke, I turn of choke after about a minute. But have to maintain engine running using throttle. If I close throttle off, the engine stops.
Have tried the tick-over screw fully in and fully out but it makes no difference to the tick-over. I know this is not right.
Any ideas on what I can try to get it running correctly?
Thanks