LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
Amal mk1
5 posts
• Page 1 of 1
Amal mk1
by robert gilchrist » Mon Aug 04, 2014 12:19 pm
Hi, Can anyone advise, on a set up for Amal 30ml mk1 carb,185 Casa kit, Ancillotti 42mm exhaust? Any help? Cheers
- robert gilchrist
- Posts: 41
- Joined: Sun Jun 01, 2014 7:31 pm
Re: Amal mk1
by St George » Tue Aug 05, 2014 3:51 pm
I thought these were designed for the big four stroke as in BSA Norton Etc. Could be wrong.
Colin
Colin
- St George
- Posts: 825
- Joined: Fri May 30, 2014 3:48 pm
Re: Amal mk1
by Dimitrios_231 » Tue Aug 05, 2014 8:51 pm
There are also two stroke versions.
I'm going to use a 30mm on a Race-Tour 195 soon.
I use a 32mm one on a 250cc but I cannot remember the jetting now.
I'm going to use a 30mm on a Race-Tour 195 soon.
I use a 32mm one on a 250cc but I cannot remember the jetting now.
-
Dimitrios_231 - Posts: 981
- Joined: Fri May 30, 2014 1:15 pm
Re: Amal mk1
by Dimitrios_231 » Tue Aug 05, 2014 10:44 pm
I have this jetting setting from the old forum.
I cannot remember who posted it,but it was for a cast iron 225cc
280 main
25 pilot
3 1/2 slide
107 needle jet
I would start with 30-35 pilot and 300-310 main,then work it down if needed.
Don't blame me if you hole the piston
On my 250 with the 32mm,I must use 40-45 pilot and 320-330 main.
I cannot remember who posted it,but it was for a cast iron 225cc
280 main
25 pilot
3 1/2 slide
107 needle jet
I would start with 30-35 pilot and 300-310 main,then work it down if needed.
Don't blame me if you hole the piston
On my 250 with the 32mm,I must use 40-45 pilot and 320-330 main.
-
Dimitrios_231 - Posts: 981
- Joined: Fri May 30, 2014 1:15 pm
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 20 guests