by AAVlover » Fri May 12, 2017 10:22 pm
Hi - i have chromedthe existing badge, and it has small holes for fixing to the holes in the legshields. Evidently later model badges had pins which were then 'pressed' to make the fix. How do you fix the ones with holes, the holes seem too small for rivets and too small for 'hammer screws', any suggestions gratefully received???
You do not have the required permissions to view the files attached to this post.
Last edited by
AAVlover on Mon May 15, 2017 4:59 pm, edited 1 time in total.