by gaz_powell » Sat Dec 01, 2018 8:16 pm
fitted plenty of these in mild steel, chrome and stainless and never had any problems.
fitted them using the standard two pint fixing bracket, 3 point bracket and the SLJ alloy type
the spacer/tubes on the casing for a standard bracket should be 25mm - just measured a spare set I have
I always put a long threaded bar/stud (x2 or 3 depending on bracket) in the casing, spacers, bracket some penny washers a nyloc nut - I`m not a fan of using the bolts that come with kit
you may need a spacer between the two tail pipe brackets - ive uses Teflon spacers fromm JL pipes and mini exhaust mounts.
I`ve found every pipe is different on the end can, sitting in different positions hence the need for differing spacers
First ones were made with 42mm u bends then they went to 48mm - what have you got ss or mild ?
Ive got 4 in service at minute and one on the shelf ; SS, Chrome and just painted so I can do photos if needed
hope this helps
if need be I can do photos and email you.