Finished stripping the outside of the mudguard earlier. It's pretty unpleasant in my unit when the weather is nice, but it looks like the warm and dryness is set to continue a while yet. I'll most likely sand blast the inside of the mudguard at work so I can hit it with POR15, but for the moment I want to get it good and straight first.
The off side is pretty much spot on
post-18211-0-59057100-1528221585.jpg
The near side is sporting some piss poor panel beating
post-18211-0-64880400-1528221647.jpg
I was aware of the dentage, but had hoped that whoever my old fella got to paint it back in '93 had done a better job! Not to worry though - this and the nearside rear floor board will be getting a bit of hammer/dolly action at some point.
You do not have the required permissions to view the files attached to this post.