Just noticed that the stub, bolt for the horn is missing or cut off at some point I’m guessing I can centre punch drill and tap it what size tap would be required.
Cheers Shane.
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
Series 2 horn
5 posts
• Page 1 of 1
Series 2 horn
by shane BBoys » Thu Apr 02, 2020 9:21 am
-
shane BBoys - Posts: 492
- Joined: Sat Sep 06, 2014 5:46 pm
- Location: Bradford
Re: Series 2 horn
by Norrie Bodge » Thu Apr 02, 2020 3:25 pm
shane BBoys wrote:Just noticed that the stub, bolt for the horn is missing or cut off at some point I’m guessing I can centre punch drill and tap it what size tap would be required.
Cheers Shane.
Drill & Tap to m6
- Norrie Bodge
- Posts: 555
- Joined: Sat Aug 16, 2014 3:34 pm
Re: Series 2 horn
by shane BBoys » Thu Apr 02, 2020 5:50 pm
It just taken me an hour to find my tap n die set, I thought it was in the conservatory where I’d last used it but no it was in the garage on top of the over spill ( beer ) fridge, so will sort it tomorrow between painting some bits for this build.
Cheers Shane.
Cheers Shane.
-
shane BBoys - Posts: 492
- Joined: Sat Sep 06, 2014 5:46 pm
- Location: Bradford
Re: Series 2 horn
by gaz_powell » Fri Apr 03, 2020 7:31 am
My API S2 never had anything. Just drilled and tapped frame and put a spot weld on it for good measure
- gaz_powell
- Posts: 3346
- Joined: Sat May 31, 2014 7:56 pm
- Location: Hartlepool
Re: Series 2 horn
by shane BBoys » Fri Apr 03, 2020 6:47 pm
gaz_powell wrote:My API S2 never had anything. Just drilled and tapped frame and put a spot weld on it for good measure
I’ve drilled and taped the square plate where the stub- bolt must have been, the frames already powder coated so welding is not and option.
Cheers Shane.
-
shane BBoys - Posts: 492
- Joined: Sat Sep 06, 2014 5:46 pm
- Location: Bradford
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: Bing [Bot] and 15 guests