DL 125 ( 225 ) RS Type

[Kirk St Moritz]

Just one of them Jazzy lol

No Porsches in this household now!!!

Been doing a little bit tonight!

Fitted an original CEV wiring connector.





Added an inline choke cable adjusted.



Made an LED rear light from a Bossata pattern GP light and a BGM LED rear light board.







That's all folks.

[johnspeed22/2]

very nice keep them pics coming we all enjoy lambretta rebuild ocd

[Kirk St Moritz]

Cyclone fitting time!

[Kirk St Moritz]

So I was about to fit the gearbox, but went to the pub instead!

So eventually got round to it........



Used MB parts


And AF cassette clutch


All stripped


Various large shims were tried


Shimmed up with a 0.2 mm clearance and a 1.6 mm large shim.


Then checked for fifth gear and cluster alignment.


Gearbox assembled


And with chain and clutch fitted!

[Kirk St Moritz]

Front end

[Kirk St Moritz]

Added an air scoop to the front hub, I'm going to mount the reed relay speed sensor from the Gamma Technologies RSTE 1000 unit to it so it moves with the suspension, rather than fixing it at the fork link pivot point.

[halesworthlambretta]

Superb or what - keep 'em coming, it inspires me to finish my rebuild.

[Kirk St Moritz]

Ta!

So it's been a while since I updated this thread cos I've been waiting for parts, but it's getting there!

So after I scratched the headset putting the steering lock in I decided to have the innocenti headset welded up to blank off the steering lock! I don't ever rely on it anyway!



Also I chickened out of painting the tanks and other tinware under the panels a bright colour and simply went for basalt Black!



Just a few things to do, such as bleed the front brake, put oil in it, fit the Mtech unit, jet the carb appropriately and get it registered.

[Fireman Ash]

Usual high standards Craig, looks superb

[Mal*1]

One word - Mint... Keep up the good work. Mines off up to Petes soon for spraying and can't wait to see finished result!

[Kirk St Moritz]

Just need to register it and run it!

[Stevepshipley]

Tidy job, well done

[Kirk St Moritz]

Ta.

All registered and ready to go.

[68Sxandy]

Very,very nice, well done.

[Tractorman]

Looks great and will be ready for the season?

[Rich Oswald]

Fookin superb Craig.

[Kirk St Moritz]

Thanks. Just got my reg plate from Tippers today so it's ready to go. Hope to be riding the coast to coast on it.

[Toddy]

I'll take a gear bar circlip then

[Kirk St Moritz]

I'll take a gear bar circlip then

I'm wise to that one now Toddy. Its got a gear selector shaft stud conversion with a nylock holding the tie bar in place!

[Toddy]

I'll take a gear bar circlip then

I'm wise to that one now Toddy. Its got a gear selector shaft stud conversion with a nylock holding the tie bar in place!

I add a nyloc nut to my spares box then