Stainless welds are not very vibration resistant too.
Titanium might be a good choice? Bang goes the pension.
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
Exhaust nickel plating
24 posts
• Page 2 of 2 • 1, 2
Re: Exhaust nickel plating
by Fast n Furious » Wed Nov 07, 2018 2:15 pm
Stainless definitely no good because of resonance differences as mentioned above.
Stainless welds are not very vibration resistant too.
Titanium might be a good choice? Bang goes the pension.
Stainless welds are not very vibration resistant too.
Titanium might be a good choice? Bang goes the pension.
-
Fast n Furious - Posts: 1657
- Joined: Sat Nov 19, 2016 3:56 am
- Location: York
Re: Exhaust nickel plating
by Scooterdude » Fri Nov 09, 2018 3:34 pm
burnside wrote:Ceramic coating?
Difficult to repair if pipe splits....as ive found out first hand! Plus its mega expensive, as in as much if not more than a new exhaust!
- Scooterdude
- Posts: 674
- Joined: Fri May 26, 2017 3:45 am
Re: Exhaust nickel plating
by Solid Air » Fri Nov 09, 2018 5:19 pm
Also, the u-bend and tail-pipe on a clubby look crap after one winter's riding 
-
Solid Air - Posts: 1010
- Joined: Sun Jun 01, 2014 10:58 pm
- Location: Cambridge
24 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users and 16 guests