Cheers chaps,
Lot of positive replies, and a lot of Luna lovers
This isn't gonna be a quick project as I have other stuff going on at the same,
But I did manage to grab 5 minutes today, so I whipped the chaincase cover off,
What a pleasure that was, no Bridge piece, floorboards or fiddly exhaust to remove.
I LOVE the simplicity of this straight away:
All looks good, I know the clutch works as when I put it in gear yesterday although the top end is seized, when rocked and clutch pulled in it disengaged and the scooter rolled forward,
So I adjusted the chain, and turned my attention to the snapped kickstart shaft.
Turns out it wasn't:
The plunger was stuck in
I will fettle that tomorrow (ish) and refit and recheck.
That just saved a few quid.
Then I sat and thought about the top end seizure, strip or let the diesel do its job and wait a week
I am kinda impatient, so I got an 11mm socket on the front sprocket and gave it a sharp jerk,
And it moved
Now it is unseized, I don't need a kickstart shaft, oh if only I had a sidecase gasket, luckily Scootopia are only 5 mins from my work,
so I will visit Dan tomorrow.
I have also taken the seat off to look at the fuel tank, as it stinks, and the seat is a hard, rock solid lump.
The original rubber base seems to have gone back to a liquid form at some stage and dripped in hard pools of molten rubber and reset all over the tank, tool kit and seat base.
So if Scootopia have base rubber and covers in stock, I will splash out and buy them.
Might be a while for next update, these things cant happen overnight.
Shaun.